Enter a different Maximum Transmission Unit (MTU) value (minimum value=68 - default=1500).Ĭonfiguring Physical Interfaces - CLI (interface).
#Show interface errors gaia mac#
An incorrect MAC address can lead to a communication failure. Enter the hardware MAC address (if not automatically received from the NIC).Ĭaution: Do not manually change the MAC address unless you are sure that it is incorrect or has changed.Select a link speed and duplex setting from the list.Select Auto Negotiation to automatically configure the link speed and duplex setting.On the Ethernet tab, configure the link speed and duplex setting, and then do one of these:.Enter the IP address and mask length in the applicable fields.Select Obtain IPv6 address automatically to get the IP address from the DHCP server.Enter the IP address and subnet mask in the applicable fields.Select Obtain IPv4 address automatically to get the IP address from the DHCP server.Select the Enable option to set the interface status to UP.Select an interface from the list and click Edit.This section includes procedures for changing physical interface parameters using the WebUI. The physical interfaces show in the list in the WebUI. Gaia automatically identifies the new or changed physical interfaces and assigns an interface name. Add, remove or replace the interface cards.You cannot add, change or remove physical interface cards while the Gaia computer is running. You cannot add or delete a physical interface using the WebUI or the CLI. Gaia automatically identifies physical interfaces (NICs) installed on the computer. This section has configuration procedures and examples for defining different types of interfaces on a Gaia platform. To see interface status using the CLI, run show interfaces all Physical Interfaces The physical interface is enabled (up) and connected to the network. The physical interface is enabled (up), but Gaia cannot find a network connection. The physical interface is disabled (Down). Double-click an interface to see its parameters.In the navigation tree, select Network Management > Network Interfaces.You can see the status of physical and logical interfaces by using the WebUI or the CLI. If this occurs, run cpstop and then cpstart in expert mode. Note - When you add, delete or make changes to interface IP addresses, it is possible that when you use the Get Topology option in SmartDashboard, the incorrect topology is shown. Alias (Secondary IP addresses for different interface types).Gaia supports these network interface types: Note :- The maximum value for auto-recovery-time for all the port security functionalities is 65535 seconds.This chapter includes configuration procedures and examples for network management. To clear the port errors on all interfaces execute the following command: (host) #clear port-error-recovery interface gigabitethernet 0/0/42 The following command clears the errors on gigabitethernet 0/0/42: Host) #clear port-error-recovery interface To recover the ports on a specific interface execute the following command: Use the CLI to manually recover the port errors. GE0/0/5 Log (MAC Limit exceed) No Auto recovery GE0/0/14 Log (Mac Limit Exceeded) No Auto recovery Pc1 Shutdown (Loop Detected) 16:45:40 (PST) GE0/0/42 Shutdown (Loop Detected) No Auto recovery Pc5 Shutdown (Loop Detected) 16:42:45 (PST) Use the following command to view the list of ports that are detected with port errors and the time at which they willīe recovered automatically, if auto-recovery is enabled: The port can be reactivated after the configured time by configuring the auto-recovery option or can be recovered manually.Įnvironment: This articles applies to Aruba Mobility Access Switches running AOS version 7.1.3.0 and above. You can apply auto-recovery-time option only if the action is shutdown A port is automatically placed in a any of the following error state by the switch because of an error condition that is encountered on the port.īased on the configuration the traffic can be either Dropped, Logged or the port can be Shutdown and When a port is in error state Shutdown, it is effectively shut down and no traffic is sent or received on that port.